FitMatch
Bonaire Filtercool pad 6050315SP (90/100 mm, medium cabinet, single)

Evaporative cooler pad kit

Bonaire Filtercool pad 6050315SP (90/100 mm, medium cabinet, single)

6050315SP

Fits 2 models

Wrong part, or your model missing? Tell us. A person checks every report.

Genuine

$117.74

Bonaire · 1 Nov

Compatible

$107.00 each

4-pack $428.00

Plumbonline · 1 Nov

Check seller

Genuine: made by Bonaire. Compatible: another brand.

Lowest compatible · $107.00 each · 4-pack $428.00

Plumbonline. Compare with genuine below. Some links earn us a commission.

Open Plumbonline

Compare 3 sellers

AUD, before delivery. Each price shows when it was checked.

Open cheapest seller · $107.00 each · 4-pack $428.00

Opens Plumbonline in a new tab. Their page is the source of truth for price, delivery and returns.

How long it lasts

Replace it when the pads are damaged or blocked, Bonaire says; check and hose them down at the start and end of summer, and have the cooler serviced every year.

After replacing: No pad reminder to reset. If your installer turned on the service reminder, the spanner icon on the Bonaire Navigator control appears after 700 hours of running; it is a service reminder, not a pad timer. Bonaire's Pad Clean function (Navigator control) runs a 20-minute wash of the pads.

How to change the 6050315SP evaporative cooler pad kit

Watch the guide or follow the steps.

No clear video for this part yet. The steps cover it.

  1. 1Isolate the cooler from the power before any work. Ensure the roof is safe to access, your ladder is securely positioned and use suitable safety equipment, Bonaire says; it recommends its trained service technicians or an authorised Climate Technologies service provider for this work.
  2. 2Remove a louvre panel: lift it about 15 mm off the corner post notch, tilt it back from the top and lift it away. Put it down where it will not be damaged.
  3. 3Take the old pad out of the louvre panel: remove the old clips, or cut off the old plastic retaining spikes with side cutters.
  4. 4Place the new pad in the louvre panel and fix it with new Filtercool clips and washers (retaining spikes on older units), pushed through the pad onto the vertical ribs until the pad sits firm against them.
  5. 5Refit the louvre and repeat for the others, then restore the power and run the cooler. Check the pads wet evenly; the Navigator control's Pad Clean function runs a 20-minute wash.
Every number this part goes by
Retail name:
6050315SP

Sellers list any of these; they are the same part.

Will it fit your appliance?

Type your model number and we'll check it against the makers' lists.

Fits these 2 Bonaire models

Bonaire2 models

VSM65/60. Bonaire sells these 90/100 mm pads singly: buy one per louvre panel, usually four.

VSM65. For an Integra made before 2015 (label VSM65/60, or product code 6050026, 6060036 or 6070036 on the data plate): it takes the 90/100 mm medium-cabinet pad 6050315SP instead.

Common questions
What does the 6050315SP fit?
The Bonaire Filtercool pad 6050315SP (90/100 mm, medium cabinet, single) fits the Bonaire VSM65/60 and VSM65.
Where can I buy the 6050315SP in Australia?
We track 3 Australian sellers for the 6050315SP; the lowest listed price when we last checked was A$107.00 at Plumbonline. Prices are re-checked daily and dated on this page.
How do I fit the 6050315SP?
No tools, a few minutes: 5 steps, listed on this page with the replacement video where the maker has one.
What happens if I don't change it?
Clogged pads pass less air and water, so the cooler blows warmer air, and old pads can smell musty.
How do I reset the reminder?
No pad reminder to reset. If your installer turned on the service reminder, the spanner icon on the Bonaire Navigator control appears after 700 hours of running; it is a service reminder, not a pad timer. Bonaire's Pad Clean function (Navigator control) runs a 20-minute wash of the pads.

Something looks wrong with the 6050315SP match? . Reports go to a person, not a bot.