FitMatch
Braemar LCS Chillcel medium pad 4-pack 115719 (120 mm)

Evaporative cooler pad kit

Braemar LCS Chillcel medium pad 4-pack 115719 (120 mm)

115719

Fits 2 models

Wrong part, or your model missing? Tell us. A person checks every report.

Genuine

See seller

Seeley International · 28 Oct

Compatible

$465.00

Plumbonline · 1 Nov

Check seller

Genuine: made by Braemar. Compatible: another brand.

Lowest compatible · $465.00

Plumbonline. Compare with genuine below. Some links earn us a commission.

Open Plumbonline

Compare 2 sellers

AUD, before delivery. Each price shows when it was checked.

PlumbonlineCompatible · checked 1 Nov$465.00Open
Seeley InternationalGenuine · no price recordedSee priceOpen
Open cheapest seller · $465.00

Opens Plumbonline in a new tab. Their page is the source of truth for price, delivery and returns.

How long it lasts

Replace it when the pads are in poor condition or salted up, Seeley says; have them checked at the service before summer, at least every 2 years on a home cooler.

After replacing: No pad reminder to reset. After fitting new pads, run Pad Flush from the MagIQtouch settings menu if your cooler has one, or fill the tank, run the pump for about 5 minutes and drain it, to clear the smell of new pads.

How to change the 115719 evaporative cooler pad kit

Watch the guide or follow the steps.

No clear video for this part yet. The steps cover it.

  1. 1Turn the cooler off at the wall control, then switch it off at the isolating switch inside the cooler. Seeley recommends an authorised Seeley dealer or service agent for any work on the roof: climbing onto the roof is hazardous, and its manuals say maintenance is for a qualified, licensed technician.
  2. 2Working at heights needs extra safety precautions, Seeley warns: only go up if you can reach the cooler safely. Remove each pad frame: insert a flat screwdriver tip into the slot and lever until it lets go, pull the frame towards you until the internal side clips release, then pivot it outwards and lift it up.
  3. 3Pull out the pad pins and washers and lift out the old pads. On the LCS, note the rebates: each 120 mm pad goes where its rebate clears the float valve or drain valve.
  4. 4Fit the new Chillcel pads with the header block at the top, and push new pins and washers through until they sit flush. Check the pins and washers are not damaged.
  5. 5Refit the frames and clips, switch the power back on and run the cooler; never run it with the pad frames off. Flush the new pads: use Pad Flush in the MagIQtouch settings menu if you have it, or fill the tank, run the pump for about 5 minutes and drain it. Check that the pads wet evenly.
Every number this part goes by
Retail name:
115719

Sellers list any of these; they are the same part.

Will it fit your appliance?

Type your model number and we'll check it against the makers' lists.

Fits these 2 Braemar models

Braemar2 models

LCS pads have rebates for the float valve and drain valve: put each pad back in the position its rebate matches.

Common questions
What does the 115719 fit?
The Braemar LCS Chillcel medium pad 4-pack 115719 (120 mm) fits the Braemar LCS280 and LCS380.
Where can I buy the 115719 in Australia?
We track 2 Australian sellers for the 115719; the lowest listed price when we last checked was A$465.00 at Plumbonline. Prices are re-checked daily and dated on this page.
How do I fit the 115719?
5 steps, listed on this page with the replacement video where the maker has one.
What happens if I don't change it?
Clogged pads pass less air and water, so the cooler blows warmer air, and old pads can smell musty.
How do I reset the reminder?
No pad reminder to reset. After fitting new pads, run Pad Flush from the MagIQtouch settings menu if your cooler has one, or fill the tank, run the pump for about 5 minutes and drain it, to clear the smell of new pads.

Something looks wrong with the 115719 match? . Reports go to a person, not a bot.