Clothes dryer lint filter
Bosch fluff filter 00096423 (WTL5200AU condenser)
00096423
Fits 2 models
Wrong part, or your model missing? Tell us. A person checks every report.
GenuineGenuine Bosch
See seller
Bosch Australia · 26 OctBosch Australia · checked 26 Oct
CompatibleCompatible option
See seller
No compatible seller tracked yetNo compatible seller tracked yet
Genuine: made by Bosch. Compatible: another brand.Genuine is made by Bosch. Compatible is made by another brand. Check the seller's page for the size and models it fits.
Compare 1 seller
AUD, before delivery. Each price shows when it was checked.
How long it lasts
Replace it when the mesh is torn or the frame is damaged; clean it after every drying cycle.
After replacing: No reset needed. Some models show a reminder to clean the filter; it clears when the door is closed and a new programme starts.
How to change the 00096423 dryer lint filter
Watch the guide or follow the steps.
- 1Open the door, remove any fluff from the door and around the door opening, and pull out the fluff filter.
- 2Remove the fluff from the shaft the filter sits in. Do not let fluff fall into the open shaft.
- 3Open the fluff filter and sweep the fluff off with your hand. If it is very dirty or blocked, rinse it with warm water and dry it thoroughly.
- 4Close the filter and push it fully back in, then close the door. Do not run the dryer without the filter or with a damaged one.
Every number this part goes by
- Retail name:
- 00096423
- Retail name:
- 96423
Sellers list any of these; they are the same part.
Will it fit your appliance?
Type your model number and we'll check it against the makers' lists.
Common questions
- What does the 00096423 fit?
- The Bosch fluff filter 00096423 (WTL5200AU condenser) fits the Bosch WTA3200AU and WTL5200AU.
- Where can I buy the 00096423 in Australia?
- We link to 1 Australian seller for the 00096423; the seller's page shows the current price.
- How do I fit the 00096423?
- No tools, a few minutes: 4 steps, listed on this page with the replacement video where the maker has one.
- What happens if I don't change it?
- Lint gets past a torn filter into the condenser or heat pump, airflow drops and each load takes longer to dry.
- Is there anything to reset afterwards?
- No reset needed. Some models show a reminder to clean the filter; it clears when the door is closed and a new programme starts.
Something looks wrong with the 00096423 match? . Reports go to a person, not a bot.