Clothes dryer foam filter
Electrolux heat pump base filter, grey 1366344032
1366344032
Fits 1 model
Wrong part, or your model missing? Tell us. A person checks every report.
GenuineGenuine Electrolux
$33.99
Electrolux Australia · 26 OctLowest genuine · Electrolux Australia · checked 26 Oct
CompatibleCompatible option
See seller
No compatible seller tracked yetNo compatible seller tracked yet
Genuine: made by Electrolux. Compatible: another brand.Genuine is made by Electrolux. Compatible is made by another brand. Check the seller's page for the size and models it fits.
Lowest price · $33.99
Electrolux Australia. Every seller we track is listed below. Some links earn us a commission. Some seller links earn us a commission, at no extra cost to you.
Compare 1 seller
AUD, before delivery. Each price shows when it was checked.
Opens Electrolux Australia in a new tab. Their page is the source of truth for price, delivery and returns.
How long it lasts
Replace it when it is torn or no longer seals; rinse it when the dryer shows the filter warning.
After replacing: No reset needed. The clean-filter notification clears after you clean the filter and start the next programme.
How to change the 1366344032 dryer foam filter
Watch the guide or follow the steps.
No clear video for this part yet. The steps cover it.
- 1When the heat exchanger filter light is on (with full loads, about every 3 cycles), open the loading door, move the release button at the bottom of the door opening and open the heat exchanger door.
- 2Turn the lever to unlock the cover, lower the filter cover, lift the door filter, then pull the heat exchanger filter out of the bottom compartment.
- 3Push the hook to open the heat exchanger filter and clean it with a moist hand, or with warm water and a scrubbing brush. Close it.
- 4Take out the small filter in the base and clean it the same way. Every 6 months, vacuum the fluff out of the heat exchanger compartment.
- 5Refit the small filter and the heat exchanger filter, close the cover, lock the lever until it snaps, close the doors and refit the door filter.
Every number this part goes by
- Retail name:
- 1366344032
Sellers list any of these; they are the same part.
Will it fit your appliance?
Type your model number and we'll check it against the makers' lists.
Fits this Electrolux model
Electrolux1 model
Common questions
- What does the 1366344032 fit?
- The Electrolux heat pump base filter, grey 1366344032 fits the Electrolux EDH3284PDW.
- Where can I buy the 1366344032 in Australia?
- We track 1 Australian seller for the 1366344032; the lowest listed price when we last checked was A$33.99 at Electrolux Australia. Prices are re-checked daily and dated on this page.
- How do I fit the 1366344032?
- No tools, a few minutes: 5 steps, listed on this page with the replacement video where the maker has one.
- What happens if I don't change it?
- Lint gets past a torn filter into the condenser or heat pump, airflow drops and each load takes longer to dry.
- Is there anything to reset afterwards?
- No reset needed. The clean-filter notification clears after you clean the filter and start the next programme.
Something looks wrong with the 1366344032 match? . Reports go to a person, not a bot.