FitMatch

The Bonaire SBB950 takes the Bonaire Filtercool pad 6080160SP (large, single: Summer Breeze SBB950/SBB1200, Celair CP900/CP1150) as its pad kit; Australian sellers list it from A$104.00 each as of 1 November 2026. Fitment confirmed against the manufacturer's compatibility list.

Bonaire SBB950

Your evaporative cooler

Evaporative cooler

Confirmed against Bonaire's list

Takes the 6080160SP

Pad kit · check the code on your old part.

Bonaire sells these pads singly: buy one per louvre panel (four).

Other Bonaire evaporative coolers that take the 6080160SP

Genuine

$148.37

Bonaire · 1 Nov

Compatible

$104.00 each

4-pack $416.00

Plumbonline · 1 Nov

Check seller

Genuine: made by Bonaire. Compatible: another brand.

Lowest compatible · $104.00 each · 4-pack $416.00

Plumbonline. Compare with genuine below. Some links earn us a commission.

Open Plumbonline

Compare 2 sellers

AUD, before delivery. Each price shows when it was checked.

Open cheapest seller · $104.00 each · 4-pack $416.00

Opens Plumbonline in a new tab. Their page is the source of truth for price, delivery and returns.

How long it lasts

Replace it when the pads are damaged or blocked, Bonaire says; check and hose them down at the start and end of summer, and have the cooler serviced every year.

After replacing: No pad reminder to reset. If your installer turned on the service reminder, the spanner icon on the Bonaire Navigator control appears after 700 hours of running; it is a service reminder, not a pad timer. Bonaire's Pad Clean function (Navigator control) runs a 20-minute wash of the pads.

How to change the pad kit in your Bonaire SBB950

Watch the guide or follow the steps.

No clear video for this part yet. The steps cover it.

  1. 1Isolate the cooler from the power before any work. Ensure the roof is safe to access, your ladder is securely positioned and use suitable safety equipment, Bonaire says; it recommends its trained service technicians or an authorised Climate Technologies service provider for this work.
  2. 2Remove a louvre: undo the thumb (transit) screw at its top, slide the louvre upward and lift it out of the unit.
  3. 3Take the old pad out of the louvre panel: remove the old clips, or cut off the old plastic retaining spikes with side cutters.
  4. 4Place the new pad in the louvre panel and fix it with new Filtercool clips and washers (retaining spikes on older units), pushed through the pad onto the vertical ribs until the pad sits firm against them.
  5. 5Refit the louvre and repeat for the others, then restore the power and run the cooler. Check the pads wet evenly; the Navigator control's Pad Clean function runs a 20-minute wash.
Every number this part goes by
Retail name:
6080160SP

Sellers list any of these; they are the same part.

About your SBB950

Bonaire evaporative cooler — Summer Breeze SBB (2015 on). Its pad kit is the Filtercool pad 6080160SP (large, single: Summer Breeze SBB950/SBB1200, Celair CP900/CP1150), part 6080160SP.

Where the model number is: The model is on the label inside the cooler or on its control box, and in the manual. Don't go on the roof to look: the manual or the installer's paperwork usually has it.

Fits these 4 models

Bonaire2 models

Celair2 models

Bonaire sells these pads singly: buy one per louvre panel (four).

Common questions
Which pad kit fits the Bonaire SBB950?
The Bonaire SBB950 takes the Bonaire Filtercool pad 6080160SP (large, single: Summer Breeze SBB950/SBB1200, Celair CP900/CP1150). Bonaire sells these pads singly: buy one per louvre panel (four).
Where can I buy the 6080160SP in Australia?
We track 2 Australian sellers for the 6080160SP; the lowest listed price when we last checked was A$104.00 at Plumbonline. Prices are re-checked daily and dated on this page.
How do I fit the 6080160SP in a Bonaire SBB950?
5 steps, listed on this page with the replacement video where the maker has one.
What happens if I don't change it?
Clogged pads pass less air and water, so the cooler blows warmer air, and old pads can smell musty.
How do I reset the reminder?
No pad reminder to reset. If your installer turned on the service reminder, the spanner icon on the Bonaire Navigator control appears after 700 hours of running; it is a service reminder, not a pad timer. Bonaire's Pad Clean function (Navigator control) runs a 20-minute wash of the pads.

Something looks wrong with the SBB950 match? . Reports go to a person, not a bot.