FitMatch

The Braemar LCS580 takes the Braemar LCS Chillcel large pad 4-pack 116242 (120 mm) as its pad kit; Australian sellers list it from A$584.00 as of 1 November 2026. Fitment confirmed against the manufacturer's compatibility list.

Braemar LCS580

Your evaporative cooler

Evaporative cooler

Confirmed against Braemar's list

116242

Takes the 116242

Pad kit · check the code on your old part.

LCS pads have rebates for the float valve and drain valve: put each pad back in the position its rebate matches.

Other Braemar evaporative coolers that take the 116242

Genuine

See seller

Seeley International · 28 Oct

Compatible

$584.00

Plumbonline · 1 Nov

Check seller

Genuine: made by Braemar. Compatible: another brand.

Lowest compatible · $584.00

Plumbonline. Compare with genuine below. Some links earn us a commission.

Open Plumbonline

Compare 2 sellers

AUD, before delivery. Each price shows when it was checked.

Open cheapest seller · $584.00

Opens Plumbonline in a new tab. Their page is the source of truth for price, delivery and returns.

How long it lasts

Replace it when the pads are in poor condition or salted up, Seeley says; have them checked at the service before summer, at least every 2 years on a home cooler.

After replacing: No pad reminder to reset. After fitting new pads, run Pad Flush from the MagIQtouch settings menu if your cooler has one, or fill the tank, run the pump for about 5 minutes and drain it, to clear the smell of new pads.

How to change the pad kit in your Braemar LCS580

Watch the guide or follow the steps.

No clear video for this part yet. The steps cover it.

  1. 1Turn the cooler off at the wall control, then switch it off at the isolating switch inside the cooler. Seeley recommends an authorised Seeley dealer or service agent for any work on the roof: climbing onto the roof is hazardous, and its manuals say maintenance is for a qualified, licensed technician.
  2. 2Working at heights needs extra safety precautions, Seeley warns: only go up if you can reach the cooler safely. Remove each pad frame: insert a flat screwdriver tip into the slot and lever until it lets go, pull the frame towards you until the internal side clips release, then pivot it outwards and lift it up.
  3. 3Pull out the pad pins and washers and lift out the old pads. On the LCS, note the rebates: each 120 mm pad goes where its rebate clears the float valve or drain valve.
  4. 4Fit the new Chillcel pads with the header block at the top, and push new pins and washers through until they sit flush. Check the pins and washers are not damaged.
  5. 5Refit the frames and clips, switch the power back on and run the cooler; never run it with the pad frames off. Flush the new pads: use Pad Flush in the MagIQtouch settings menu if you have it, or fill the tank, run the pump for about 5 minutes and drain it. Check that the pads wet evenly.
Every number this part goes by
Retail name:
116242

Sellers list any of these; they are the same part.

About your LCS580

Braemar evaporative cooler — Supercool LCS (2014). Its pad kit is the LCS Chillcel large pad 4-pack 116242 (120 mm), part 116242.

Where the model number is: The model is on the label inside the cooler or on its control box, and in the manual. Don't go on the roof to look: the manual or the installer's paperwork usually has it.

Fits these 2 Braemar models

Braemar2 models

LCS pads have rebates for the float valve and drain valve: put each pad back in the position its rebate matches.

Common questions
Which pad kit fits the Braemar LCS580?
The Braemar LCS580 takes the Braemar LCS Chillcel large pad 4-pack 116242 (120 mm). LCS pads have rebates for the float valve and drain valve: put each pad back in the position its rebate matches.
Where can I buy the 116242 in Australia?
We track 2 Australian sellers for the 116242; the lowest listed price when we last checked was A$584.00 at Plumbonline. Prices are re-checked daily and dated on this page.
How do I fit the 116242 in a Braemar LCS580?
5 steps, listed on this page with the replacement video where the maker has one.
What happens if I don't change it?
Clogged pads pass less air and water, so the cooler blows warmer air, and old pads can smell musty.
How do I reset the reminder?
No pad reminder to reset. After fitting new pads, run Pad Flush from the MagIQtouch settings menu if your cooler has one, or fill the tank, run the pump for about 5 minutes and drain it, to clear the smell of new pads.

Something looks wrong with the LCS580 match? . Reports go to a person, not a bot.