FitMatch

The Bullfrog Spas A8L takes the Bullfrog Spas Simplicity flat filter, 6-pack (235 x 265 mm) (part FILTER-BF-SIMPL-6PK) as its cartridge; replace it every 3 months; Australian sellers list it from A$33.17 each as of 30 October 2026. Fitment confirmed against the manufacturer's compatibility list.

Your spa

Spa

Confirmed against Bullfrog Spas's list

FILTER-BF-SIMPL-6PK

Takes the FILTER-BF-SIMPL-6PK

Cartridge · every 3 months · check the code on your old part.

2023 and later A Series spas take the flat Simplicity filter; earlier A Series spas used round cartridges. The 6-pack is six filters.

Other Bullfrog Spas that take the FILTER-BF-SIMPL-6PK

Genuine

$33.17 each

6-pack $199.00

Spa Supplies · 30 Oct

Compatible

See seller

No compatible seller tracked yet

Genuine: made by Bullfrog Spas. Compatible: another brand.

Lowest price · $33.17 each · 6-pack $199.00

Spa Supplies. Every seller we track is listed below. Some links earn us a commission.

Open Spa Supplies

Compare 1 seller

AUD, before delivery. Each price shows when it was checked.

Open cheapest seller · $33.17 each · 6-pack $199.00

Opens Spa Supplies in a new tab. Their page is the source of truth for price, delivery and returns.

Not due yet?

Get a nudge when your cartridge is due — it's every 3 months. One email two weeks before, no newsletter. Manage or stop it anytime.

Also saves the model to a FitMatch account under this address; the email signs you in, no password.

How to change the cartridge in your Bullfrog Spas A8L

Watch the guide or follow the steps.

Bullfrog™ Spas - Filtration System · Alpine Spas™ - New Zealand & Australia (official)
  1. 1Switch the spa off at the isolating switch or main breaker (Bullfrog: turn off main power to the spa).
  2. 2A Series: remove the JetPak in front of the Simplicity filter housing, the first JetPak to the right of the main control. M Series and Swim Series: see your owner's manual for where the filter is.
  3. 3Reach into the jet pod, grasp the handle of the Simplicity filter holder, push it toward the inside of the spa and lift it out.
  4. 4Open the holder, lift the old filter out by its loop and fit a new one with the glue lines showing: slide one end under the retention slots and press the looped end down.
  5. 5Snap the holder back into the housing with a back-and-down motion, refit the JetPak and turn the power back on.
Every number this part goes by
Retail name:
Bullfrog Simplicity filter
Retail name:
Bullfrog Simplicity flat filter
Retail name:
FILTER-BF-SIMPL-6PK

Sellers list any of these; they are the same part.

About your A8L

Bullfrog Spas — Bullfrog A Series. Its cartridge is the Simplicity flat filter, 6-pack (235 x 265 mm), part FILTER-BF-SIMPL-6PK, changed every 3 months.

Where the model number is: The model (A7L, M8) is on your purchase papers, and the serial number sticker is on the equipment compartment. A Series spas from 2023 have the flat Simplicity filter; older ones take round cartridges.

Fits these 13 Bullfrog Spas models

Bullfrog Spas13 models

M6, M7, M8, M9. Takes the flat Simplicity filter. The 6-pack is six filters.

The other 9 models. 2023 and later A Series spas take the flat Simplicity filter; earlier A Series spas used round cartridges. The 6-pack is six filters.

Common questions
Which cartridge fits the Bullfrog Spas A8L?
The Bullfrog Spas A8L takes the Bullfrog Spas Simplicity flat filter, 6-pack (235 x 265 mm) (part FILTER-BF-SIMPL-6PK). 2023 and later A Series spas take the flat Simplicity filter; earlier A Series spas used round cartridges. The 6-pack is six filters.
How often should I replace the cartridge in my Bullfrog Spas A8L?
Every 3 months, or sooner if the cartridge light comes on.
Where can I buy the FILTER-BF-SIMPL-6PK in Australia?
We track 1 Australian seller for the FILTER-BF-SIMPL-6PK; the lowest listed price when we last checked was A$33.17 at Spa Supplies. Prices are re-checked daily and dated on this page.
How do I fit the FILTER-BF-SIMPL-6PK in a Bullfrog Spas A8L?
5 steps, listed on this page with the replacement video where the maker has one.
What happens if I don't change it?
A clogged cartridge slows the flow and the pump works harder, and a torn one lets dirt back into the water, so the pool or spa clouds.
How do I reset the cartridge light?
The A Series status light gives a slow fading flash when a filter needs replacing; mark the reminder as done on the control screen after fitting the new filter and the light returns to solid white (Bullfrog A Series manual).

Something looks wrong with the A8L match? . Reports go to a person, not a bot.