FitMatch

The Waterco Electrochlor 20A takes the Waterco Electrochlor 20A electrode assembly 64428611 as its cell; Australian sellers list it from A$325.00 as of 31 October 2026. Fitment confirmed against the manufacturer's compatibility list.

Your salt chlorinator

Salt chlorinator

Confirmed against Waterco's list

Takes the 64428611

Cell · check the code on your old part.

Electrode assembly only: it fits your existing cell body.

Other Waterco salt chlorinators that take the 64428611

Genuine

See seller

No genuine seller tracked yet

Compatible

$325.00

Pool & Spa Warehouse · 31 Oct

Check seller

Genuine: made by Waterco. Compatible: another brand.

Lowest compatible · $325.00

Pool & Spa Warehouse. Compare with genuine below. Some links earn us a commission.

Open Pool & Spa Warehouse

Compare 3 listings from 2 sellers

AUD, before delivery. Each price shows when it was checked.

Open cheapest seller · $325.00

Opens Pool & Spa Warehouse in a new tab. Their page is the source of truth for price, delivery and returns.

How long it lasts

Replace it when it no longer makes enough chlorine even though the run time, output setting, salt level and water balance are right and the plates are clean, Waterco says; it gives no set life.

After replacing: No reset needed. Set the chlorinator back to On or Auto after fitting and check the output.

How to change the cell in your Waterco Electrochlor 20A

Watch the guide or follow the steps.

No clear video for this part yet. The steps cover it.

  1. 1Set the chlorinator to off and turn the filter pump off.
  2. 2Disconnect the cables from the cell's terminals.
  3. 3Unscrew the barrel unions and take the cell off the pipework, then remove the old electrode assembly from the cell body.
  4. 4Fit the new electrode assembly with its O-rings seated, refit the cell and tighten the unions.
  5. 5Reconnect the cables, start the pump and check for leaks, then turn the chlorinator back on.
Every number this part goes by
Retail name:
64428611

Sellers list any of these; they are the same part.

About your Electrochlor 20A

Waterco salt chlorinator — Electrochlor salt chlorinator. Its cell is the Electrochlor 20A electrode assembly 64428611, part 64428611.

Where the model number is: The model and output are on the label on the power supply or control box near the pump. Switch the chlorinator and pump off at the power point before you touch the cell.

Fits these 2 Waterco models

Electrode assembly only: it fits your existing cell body.

Common questions
Which cell fits the Waterco Electrochlor 20A?
The Waterco Electrochlor 20A takes the Waterco Electrochlor 20A electrode assembly 64428611. Electrode assembly only: it fits your existing cell body.
Where can I buy the 64428611 in Australia?
We track 2 Australian sellers for the 64428611; the lowest listed price when we last checked was A$325.00 at Pool & Spa Warehouse. Prices are re-checked daily and dated on this page.
How do I fit the 64428611 in a Waterco Electrochlor 20A?
5 steps, listed on this page with the replacement video where the maker has one.
What happens if I don't change it?
A worn cell makes too little chlorine, so the water turns green or cloudy, and turning the output up only wears it faster.
Is there anything to reset afterwards?
No reset needed. Set the chlorinator back to On or Auto after fitting and check the output.

Something looks wrong with the Electrochlor 20A match? . Reports go to a person, not a bot.