FitMatch

Zip replacement filters

Which replacement filter each of the 20 Zip water taps and under-sink systems sold in Australia takes, with dated prices from 6 Australian sellers, genuine and compatible side by side.

Most take the 93701 (13 of 20 models), from $80.00. Check yours below.

Compatible · Amazon AU$80.00Genuine · Amazon AU$195.00All 6 sellers
Showing 20 of 20 Zip models

MicroPurity 0.2 micron filter 93701 (size 1, residential)takes 93701

GlobalPlus 0.2 micron filter cartridge 91290 (G4 HydroTap)takes 91290

Sub-micron (0.5 micron) filter 91240takes 91240

How to change your Zip filter

Steps for the MicroPurity 0.2 micron filter 93701 (size 1, residential) (93701), the water filter 19 Zip models take. Change it every 12 months.

How to change the filter on a HydroTap G5 Command Centre · ZipWater (official)
  1. 1Have a bucket and a towel ready. Open the filter door on the front of the command centre under the sink.
  2. 2Start Filter flush on the screen, which shuts off the water. Put the flush line in the bucket and open and close its tap to release the pressure.
  3. 3Put the towel under the filter. Turn the cartridge a quarter turn to the left and pull it straight down; some water will drip.
  4. 4Unpack the new 93701, take off the sanitary cap and write today's date on the label. Do not touch the O-rings.
  5. 5Wet the O-rings with tap water, push the cartridge up into the head and turn it a quarter turn to the right until it stops.
  6. 6Open the flush line's tap and run the flush (about 10 litres over 2 minutes). Close the tap and put the line back.
  7. 7Go to Filter reset on the screen and reset the internal filter, then close the door.

Different steps for GlobalPlus 0.2 micron filter cartridge 91290 (G4 HydroTap) · Different steps for sub-micron (0.5 micron) filter 91240

Reset the filter light

On a HydroTap, open Filter reset on the command centre screen after the flush and reset the internal filter counter. A ChillTap, Filter Tap or mixer has its own guide.

Get a reminder when your Zip filter is due

Most Zip models here change it every 12 months. One email two weeks before, no newsletter. Type the model from the sticker and we set the date for that model.

Optional. Leave it blank and we ask for it in the email.

Common questions

How often should I change a Zip filter?
Every 12 months for the MicroPurity 0.2 micron filter 93701 (size 1, residential), the most common Zip water filter here. Each model page shows the interval for its own water filter.
What happens if I don't change the water filter?
The carbon stops reducing chlorine taste and odour and the flow from the tap slows as the cartridge clogs; a boiling-water tap with a scale-reducing filter builds scale in its tank faster.
Does Zip make a compatible filter?
Zip makes the genuine filter. Compatible filters for Zip models are made by other companies to the same shape and flow rate, and Australian sellers we track list both; each part page shows the genuine and compatible prices side by side and the certifications we could confirm.
How do I reset the filter light on a Zip tap or under-sink system?
On a HydroTap, open Filter reset on the command centre screen after the flush and reset the internal filter counter. A ChillTap, Filter Tap or mixer has its own guide.
All 20 Zip filtered water taps we list, A to Z

Brand names describe compatibility only; FitMatch is independent of Zip. Fitment sources are recorded on every model page.