The EGO ST1210E takes the EGO AS1302 spool assembly, 2.0 mm twisted line (5 m) as its spool; Australian sellers list it from A$19.95 as of 30 October 2026. Fitment confirmed against the manufacturer's compatibility list.
Your line trimmer
EGO ST1210E
Line trimmer
Confirmed against EGO's listConfirmed against EGO's own compatibility list
Not yours? Change
Takes the AS1302 spool
AS1302 spool assembly, 2.0 mm twisted line (5 m) · check the code on your old part before ordering.
Your line trimmer
Line trimmer
Confirmed against EGO's listConfirmed against EGO's own compatibility list
Takes the AS1302
Spool · check the code on your old part.
Other EGO line trimmers that take the AS1302
GenuineGenuine EGO
$19.95
Australian Landscape Supplies · 30 OctLowest genuine · Australian Landscape Supplies · checked 30 Oct
CompatibleCompatible option
See seller
No compatible seller tracked yetNo compatible seller tracked yet
Genuine: made by EGO. Compatible: another brand.Genuine is made by EGO. Compatible is made by another brand. Check the seller's page for the size and models it fits.
Lowest price · $19.95
Australian Landscape Supplies. Every seller we track is listed below. Some links earn us a commission. Some seller links earn us a commission, at no extra cost to you.
Compare 1 seller
AUD, before delivery. Each price shows when it was checked.
Opens Australian Landscape Supplies in a new tab. Their page is the source of truth for price, delivery and returns.
How long it lasts
Replace it when the line on the spool runs out; tap the head to feed more line until then.
After replacing: No reset needed.
How to change the spool in your EGO ST1210E
Watch the guide or follow the steps.
- 1Remove the battery pack.
- 2Press the two release tabs on the spool base and pull the spool retainer out.
- 3Take out the old spool and clean the retainer, spool area and spool base.
- 4Place the pre-wound spool into the retainer with its notches lined up with the retainer eyelets.
- 5Line up the retainer slots with the tabs on the spool base and press the retainer down evenly until it snaps into place.
Every number this part goes by
- Retail name:
- AS1302
Sellers list any of these; they are the same part.
About your EGO ST1210E
EGO line trimmer — POWER+ 56V line trimmers (bump head). Its spool is the AS1302 spool assembly, 2.0 mm twisted line (5 m), part AS1302.
Where the model number is: The model is on the rating label on the motor housing or the shaft (Ryobi OLT1832, Ozito PXCLTS-018). Take the battery out or switch off before you turn the head over; the old spool's own code is often moulded on it.
Common questions
- Which spool fits the EGO ST1210E?
- The EGO ST1210E takes the EGO AS1302 spool assembly, 2.0 mm twisted line (5 m).
- Where can I buy the AS1302 in Australia?
- We track 1 Australian seller for the AS1302; the lowest listed price when we last checked was A$19.95 at Australian Landscape Supplies. Prices are re-checked daily and dated on this page.
- How do I fit the AS1302 in an EGO ST1210E?
- No tools, a few minutes: 5 steps, listed on this page with the replacement video where the maker has one.
- What happens if I don't change it?
- The trimmer stops cutting when the line runs out, and line of the wrong diameter jams the head or strains the motor.
- Is there anything to reset afterwards?
- No reset needed.
Something looks wrong with the ST1210E match? . Reports go to a person, not a bot.