The EGO ST1500E-F takes the EGO AS1302 spool assembly, 2.0 mm twisted line (5 m) as its spool; Australian sellers list it from A$19.95 as of 30 October 2026. Fitment confirmed against the manufacturer's compatibility list.
Your line trimmer
EGO ST1500E-F
Line trimmer
Confirmed against EGO's listConfirmed against EGO's own compatibility list
Not yours? Change
Takes the AS1302 spool
AS1302 spool assembly, 2.0 mm twisted line (5 m) · check the code on your old part before ordering.
Your line trimmer
Line trimmer
Confirmed against EGO's listConfirmed against EGO's own compatibility list
Takes the AS1302
Spool · check the code on your old part.
Other EGO line trimmers that take the AS1302
GenuineGenuine EGO
$19.95
Australian Landscape Supplies · 30 OctLowest genuine · Australian Landscape Supplies · checked 30 Oct
CompatibleCompatible option
See seller
No compatible seller tracked yetNo compatible seller tracked yet
Genuine: made by EGO. Compatible: another brand.Genuine is made by EGO. Compatible is made by another brand. Check the seller's page for the size and models it fits.
Lowest price · $19.95
Australian Landscape Supplies. Every seller we track is listed below. Some links earn us a commission. Some seller links earn us a commission, at no extra cost to you.
Compare 1 seller
AUD, before delivery. Each price shows when it was checked.
Opens Australian Landscape Supplies in a new tab. Their page is the source of truth for price, delivery and returns.
How long it lasts
Replace it when the line on the spool runs out; tap the head to feed more line until then.
After replacing: No reset needed.
How to change the spool in your EGO ST1500E-F
Watch the guide or follow the steps.
- 1Remove the battery pack.
- 2Press the two release tabs on the spool base and pull the spool retainer out.
- 3Take out the old spool and clean the retainer, spool area and spool base.
- 4Place the pre-wound spool into the retainer with its notches lined up with the retainer eyelets.
- 5Line up the retainer slots with the tabs on the spool base and press the retainer down evenly until it snaps into place.
Every number this part goes by
- Retail name:
- AS1302
Sellers list any of these; they are the same part.
About your EGO ST1500E-F
EGO line trimmer — POWER+ 56V line trimmers (bump head). Its spool is the AS1302 spool assembly, 2.0 mm twisted line (5 m), part AS1302.
Where the model number is: The model is on the rating label on the motor housing or the shaft (Ryobi OLT1832, Ozito PXCLTS-018). Take the battery out or switch off before you turn the head over; the old spool's own code is often moulded on it.
Common questions
- Which spool fits the EGO ST1500E-F?
- The EGO ST1500E-F takes the EGO AS1302 spool assembly, 2.0 mm twisted line (5 m).
- Where can I buy the AS1302 in Australia?
- We track 1 Australian seller for the AS1302; the lowest listed price when we last checked was A$19.95 at Australian Landscape Supplies. Prices are re-checked daily and dated on this page.
- How do I fit the AS1302 in an EGO ST1500E-F?
- No tools, a few minutes: 5 steps, listed on this page with the replacement video where the maker has one.
- What happens if I don't change it?
- The trimmer stops cutting when the line runs out, and line of the wrong diameter jams the head or strains the motor.
- Is there anything to reset afterwards?
- No reset needed.
Something looks wrong with the ST1500E-F match? . Reports go to a person, not a bot.